Impreza Wagon FWD F4-1820cc 1.8L SOHC (1995)
Lower Side Moulding / Trim: Service and Repair
Body Protector
REMOVAL
NOTE: Do not re-use protector.
Type A and B: Protector is attached to body with clips. While holding end of protector by hand, force protector out.
Type C: Protector is attached to body with clips. Remove door inner trim, and detach protector by pushing clip pawl from inside.
Type D: Protector is attached to body with clips. While holding end of protector by hand, force protector out.
INSTALLATION
Type A: Insert clip pins into holes in body, then fit end cap buffers into place.
Type B: Insert spin weld clips into holes in body, then fit bushings into place.
Type C and D: Align the clips with holes in body and insert them.
NOTE: Install clips in standard holes first