Impreza Wagon FWD F4-1820cc 1.8L SOHC (1995)
Heated Oxygen Sensor: Testing and Inspection
A faulty oxygen sensor will set code 32 in the on-board diagnostic system. Refer to the schematic diagram and test the sensor with the diagnostic chart.
Wire color code identification:
L:
Blue
B:
Black
Y:
Yellow
G:
Green
R:
Red
W: White
Br: Brown
Lg: Light green
Gr: Gray
OXYGEN SENSOR DIAGNOSTIC CHART
CHECK ECM VOLTAGE
With engine warmed up and idling, measure voltage between ECM connector terminal (E30)10 and ground. It should read 0.1 - 1.0 Volts.
NOTE: Problems with the oxygen sensor heater circuit will cause the sensor to deactivate.
CHECK OXYGEN SENSOR
1. With engine idling at operating temperature, disconnect oxygen sensor connector.
2. Measure voltage between oxygen sensor terminal #4 and ground. It should read 0.1 - 1.0 Volts.
CHECK HARNESS BETWEEN ECU AND OXYGEN SENSOR
Harness Test