Impreza WRX F4-2.0L DOHC Turbo (2004)
Air Bag Control Module: Service and Repair
Airbag Control Module
REMOVAL
CAUTION:
-
Do not disassemble the airbag control module.
-
If the airbag control module is deformed or if water damage is suspected, replace the airbag control module with a new genuine part.
-
Do not drop the airbag control module.
-
After removal, keep the airbag control module on a dry, clean surface away from moisture, heat, and dust.
1. Turn the ignition switch OFF.
2. Disconnect the ground terminal from battery, and wait for at least 20 seconds before starting work.
3. Remove the console box.
4. Disconnect the connector from the airbag control module.
5. Using T40(R) TORX bit (Tamper resistant type), remove the four TORX(R) bolts.
INSTALLATION
CAUTION: Use new TORX(R) bolts during re-assembly. Install in the reverse order of removal.