Impreza WRX STI F4-2.5L DOHC Turbo (2007)
4. Remove the brake pedal pad.
ASSEMBLY
1. Attach the stop light switch, etc. to pedal bracket temporarily.
2. Clean the inside of bores of clutch pedal and brake pedal, apply grease, and set the bushings into bores.
3. Align bores of the pedal bracket, clutch pedal and brake pedal, attach the brake pedal return spring, and then install the pedal bolt.
NOTE: Clean up the inside of bushings and apply grease before installing spacer.
Tightening torque:
T. 30 Nm (3.1 kgf-m, 22.1 ft. lbs.)
4. Adjust the stop light switch position after installing the brake pedal to vehicle.
INSPECTION
1. Move the brake and clutch pedal pads in the lateral direction with a force of approximately 10 Nm (1 kgf, 2 ft. lbs.) to ensure pedal
deflection is in specified range.
CAUTION: If excessive deflection is noted, replace the bushings with new ones.
Deflection of brake and clutch pedal.
Service limit 5.0 mm (0. 197 inch) or less
