Impreza WRX STI F4-2.5L DOHC Turbo (2007)
Brake Pad: Service and Repair
Rear
Rear Brake Pad
REMOVAL
1. 14 INCH TYPE
1. Set the vehicle on a lift.
2. Loosen the wheel nuts.
3. Lift-up the vehicle, and then remove the rear wheel.
4. Remove the lower caliper bolt.
5. Raise the caliper body upward and support it.
NOTE: Do not disconnect the brake hose from caliper body.
6. Remove the pad.
NOTE: If the brake pad is difficult to remove, use the same procedure as for front disc brake pad.
2. 15 INCH TYPE
1. Set the vehicle on a lift.
2. Loosen the wheel nuts.
3. Lift-up the vehicle, and then remove the rear wheel.
4. Remove the M clip.
5. Remove the two pad pins.
6. Remove the cross spring.