Impreza WRX STI F4-2.5L DOHC Turbo (2007)
7. Apply a coat of specified grease to the guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. K0779GA 102)
8. Install the guide pin boot on support.
9. Install the lock pin boot on support, and then insert the lock pin sleeve into place.
2. 15 INCH TYPE
1. Clean the caliper body interior using brake fluid.
2. Apply a coat of brake fluid to the piston seal and fit piston seal in groove on caliper body.
3. Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4. Apply a coat of specified grease to the boot and install it in the groove on piston.
Grease: NIGLUBE RX-2 (Part No. K0779GA 102)
5. Insert the piston into cylinder.
CAUTION: Do not force the piston into cylinder.
6. Install the piston boot to caliper body, and then attach boot ring.
