Impreza WRX STI F4-2.5L DOHC Turbo (2007)
8) Install the jack-up plate.
9) Install the air intake duct.
10) Install the air intake duct, air cleaner upper cover and air intake boot.
11) Connect the battery ground cable to battery.
12) Feed the specified fluid.
CAUTION:
Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
13) Finally check clearance between pipes and/or hoses, as shown above. If cruise control actuator-to-power steering hose clearance is less than 10
mm (0-39 inch), move the portion (A) secured by clamp to other portion, or bend portion (B) to adjust.
INSPECTION
Check all disassembled parts for wear, damage or other abnormalities. Repair or replace faulty parts as required.
CAUTION:
Although the surface layer materials of rubber hoses have excellent weathering resistance, heat resistance and resistance for low temperature
brittleness, they are likely to be damaged chemically by brake fluid, battery electrolyte, engine oil and automatic transmission fluid and their service
lives are to be very shortened. It is very important to keep the hoses free from before mentioned fluids and to wipe out immediately when the hoses are
adhered with the fluids.
Since the resistances for heat or low temperature brittleness are gradually declining according to time accumulation of hot or cold conditions for the
