Impreza WRX STI F4-2.5L DOHC Turbo (2007)
REAR BUSHING
1) Install the rear bushing to transverse link, and then align the aligning marks scribed on the two.
2) Tighten the new self-locking nut.
NOTE:
While holding the rear bushing so as not to change position of aligning marks, tighten the self-locking nut.
Tightening torque:
190 Nm (19.4 kgf-m, 140 ft. lbs.)
INSPECTION
1) Check the transverse link for wear, damage and cracks, and correct or replace if defective.
2) Check the bushings for large cracks, fatigue or damage.
3) Check the rear bushing for oil leaks.