Impreza WRX STI F4-2.5L DOHC Turbo (2007)
19) Put a new band through the clip and wind twice in alignment with band groove of boot.
20) Tighten the band by using the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE:
Tighten the band until it cannot be moved by hand.
21) Tap on the clip with punch provided at the end of ST.
ST 925091000 BAND TIGHTENING TOOL
CAUTION:
Tap to an extent that the boot underneath is not damaged.
22) Cut off the band with an allowance of about 10 mm (0.39 inch) left from clip, and bend this allowance over clip.
CAUTION:
Be careful so that the end of band is in close contact with clip.
23) Extend and retract the PTJ to provide equal grease coating.
BJ+DOJ TYPE
NOTE:
Use specified grease.
BJ side: NTG2218-M (Part No. 28395AG030)
DOJ side: NKG205 (Part No. 28495AGO10)
1) Install the BJ boot in specified position, and fill it with 60 to 70 g (2.12 to 2.47 ounces) of specified grease.
2) Place the DOJ boot at the center of shaft.
3) Wrap the shaft splines with vinyl tape.