Impreza WRX STI F4-2.5L DOHC Turbo (2007)
11) Install the circlip in the groove on DOJ outer race.
NOTE:
^
Assure the balls, cage and inner race are completely fitted in the outer race of DOJ.
^
Exercise care not to place the matched position of circlip in ball groove of outer race.
^
Pull the shaft lightly and assure that the circlip is completely fitted in groove.
12) Apply an even coat of the specified grease [20 to 30 g (0.71 to 1.06 ounces)] to the entire inner surface of boot. Also apply grease to shaft.
13) Install the DOJ boot taking care not to twist it.
NOTE:
^
Inside of the larger end of DOJ boot and boot groove shall be cleaned so as to be free from grease and other substances.
^
When installing the DOJ boot, position the outer race of DOJ at center of its travel.
14) Put a new band through the clip and wind twice in alignment with band groove of boot.
NOTE:
When tightening the boot, exercise care so that air within boot is appropriate.
15) Tighten the band using the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE:
Tighten the band until it cannot be moved by hand.
16) Tap on the clip with the punch provided at the end of ST.
ST 92509looo BAND TIGHTENING TOOL
NOTE:
Tap to an extent that the boot underneath is not damaged.