Impreza WRX STI F4-2.5L DOHC Turbo (2007)
2) Install the intercooler.
3) Connect the battery ground cable to battery.
CROSSMEMBER AND CUSHION RUBBER
1) Install the rear cushion rubber.
Tightening torque:
35 Nm (3.6 kgf-m, 25.8 ft. lbs.)
2) Install the crossmember.
3) Remove the transmission jack.
4) Install the center exhaust pipe.
5) Install the rear exhaust pipe and muffler.
INSPECTION
Repair or replace parts if the results of the inspection below are not satisfactory.
PITCHING STOPPER
Make sure that the pitching stopper is not bent or damaged. Make sure that the rubber is not stiff, cracked, or otherwise damaged.
CROSSMEMBER AND CUSHION RUBBER
Make sure that the crossmember is not bent or damaged. Make sure that the cushion rubber is not stiff, cracked, or otherwise damaged.