Impreza WRX STI F4-2.5L Turbo (2008)
Cross-Member: Service and Repair
Front Suspension
Front Crossmember Support Plate
Front Crossmember Support Plate
REMOVAL
1) Lift up the vehicle.
2) Remove the front under cover.
3) Remove the bolt and remove front crossmember support plate.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 60 N-m (6.1 kgf-m, 44.3 ft-lb)
Front Crossmember
Front Crossmember
REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the front exhaust pipe.
3) Remove the front crossmember support plate.
4) Remove the front stabilizer.
5) Disconnect the tie-rod end from housing.
6) Remove the front arm.
7) Remove the nuts attaching the engine mount cushion rubber to crossmember.
8) Remove the steering universal joint.
9) Disconnect the power steering hose from steering gearbox.
10) Lift the engine approx. 10 mm (0.39 in) using a chain block.
11) Support the crossmember with a jack, remove the bolts securing crossmember to body, and then gradually lower the crossmember with steering
gearbox as a unit.
CAUTION: When removing the crossmember downward, be careful that the tie-rod end does not interfere with drive shaft boot.