L-Series Sedan (3 Door) 2WD F4-1781cc 1.8L SOHC Turbo (MPFI) (1987)
Timing Belt: Service Precautions
GENERAL PRECAUTIONS:
-
Before disassembling engine, install ENGINE STAND 499817000 x 2.
-
Before installing engine stand, disconnect air duct, turbo cooling hose, turbocharger and front exhaust pipe from the engine.
-
All parts should be thoroughly cleaned, paying special attention to the engine oil passages, pistons and bearings.
-
Rotating parts and sliding parts such as piston, bearing and gear should be coated with oil prior to assembly.
-
Be careful not to let oil, grease or coolant contact the timing belt and clutch disc.
-
All removed parts, if to be reused, should be reinstalled in the original positions and directions.
-
Gaskets and lock washers must be replaced with new ones. Liquid gasket should be used where specified to prevent leakage.
-
Bolts, nuts and washers should be replaced with new ones as required.
-
Even if necessary inspections have been made in advance, proceed with assembly work while making rechecks.
-
Belt tensioning must only be performed on a COLD engine.
-
When installing a new belt, rotate the crankshaft in a clockwise direction three times prior to tensioning of the belt.