Legacy F4-2.5L DOHC Turbo (2005)
3
Gradually tighten the camshaft cap and oil control valve assembly in at least two stages in alphabetical sequence shown in the figure, and then
tighten to the specified torque.
4
After tightening the camshaft cap, ensure the camshaft rotates only slightly while holding it at "base circle".
3. Camshaft oil seal installation:
Apply grease to the new oil seal lips and press onto the front end of camshaft by using ST1 and ST2.
NOTE: Use a new oil seal.
ST1 499587600 OIL SEAL INSTALLER
ST2 499597200 OIL SEAL GUIDE
4. Rocker cover installation:
1
Install the gasket on rocker cover. Install the peripheral gasket and ignition coil gasket.