Legacy F4-2.5L DOHC Turbo (2005)
Harmonic Balancer - Crankshaft Pulley: Service and Repair
The content of this article / image reflects Manual update # 18-145-09 dated 01/07/10.
Crank Pulley
REMOVAL
NOTE:
When replacing the single part, perform the work with the engine installed to vehicle body.
1) Remove the V-belts.
2) Use the ST to lock the crank pulley, and remove the crank pulley bolt.
ST 499977100 / 499977400 CRANK PULLEY WRENCH
3) Remove the crank pulley.
INSTALLATION
METHOD WITHOUT ANGLE GAUGE
1) Clean the crankshaft thread using compressed air.
2) Install the crank pulley.
3) Apply engine oil to the crank pulley bolt seat and thread.
4) Tighten the crank pulley bolts.
1) Use the ST to lock the crank pulley, and temporarily tighten the crank pulley bolt.
ST 499977100 / 499977400 CRANK PULLEY WRENCH
2) Draw reference lines (A) and (B) using a marker to set the socket to the crank pulley bolt as shown in the figure.
ST 499977100 / 499977400 CRANK PULLEY WRENCH
NOTE:
Set the socket onto the crank pulley bolt so that reference lines (A) and (B) is visible.