Legacy F4-2.5L DOHC Turbo (2005)
2. Tighten the bolts which hold the power steering pump bracket.
3. Interconnect the pressure hose and suction hose.
Tightening torque: Eye bolt 39 Nm (4.0 kgf-cm, 28.9 ft. lbs.)
CAUTION: If a hose is twisted at this step, take care the hose may come into contact with some other parts.
^
Non-turbo model
^
Turbo model
4. Connect the connector to power steering pump switch.
5. Install the V-belts to oil pump.
6. Check the tension of V-belt.
7. Tighten the belt tension bolt.
Tightening torque: 25 Nm (2.5 kgf-cm, 18.4 ft. lbs.)
8. Install the pulley belt cover.
9. Install the air intake duct.
10. Connect the ground cable to battery.
11. Feed the specified power steering fluid.
CAUTION: Never start the engine before feeding the fluid otherwise vane pump might be seized up.
H6 MODEL
1. Install the oil pump to bracket.