Legacy F4-2.5L DOHC Turbo (2005)
Transmission Mount: Service and Repair
Transmission Mounting System
REMOVAL
PITCHING STOPPER
1. Disconnect the ground cable from battery.
2. Remove the intercooler. (Turbo model)
3. Remove the air intake chamber. (Non-turbo model)
4. Remove the pitching stopper.
TRANSMISSION REAR CROSSMEMBER & REAR CUSHION RUBBER
1. Disconnect the ground cable from battery.
2. Jack-up the vehicle and support it with rigid racks.
3. Remove the center exhaust pipe, rear exhaust pipe and muffler. (Turbo model)
4. Remove the front exhaust pipe, rear exhaust pipe and muffler. (Non-turbo model)
5. Remove the heat shield cover.
6. Set the transmission jack under the transmission. Make sure that the support plate of transmission jack does not touch the oil pan.
7. Remove the transmission rear crossmember.
8. Remove the rear cushion rubber from transmission.
INSTALLATION
PITCHING STOPPER
1. Install the pitching stopper.
Tightening torque: