Legacy F4-2.5L DOHC Turbo (2005)
Clutch Slave Cylinder: Service and Repair
Operating Cylinder
REMOVAL
1. Remove the air intake chamber.
2. Disconnect the clutch hose from operating cylinder.
CAUTION: Cover the hose joint to prevent clutch fluid from flowing out.
3. Remove the operating cylinder from transmission.
INSTALLATION
1. Install in the reverse order of removal.
NOTE: Before installing the operating cylinder, apply grease (SUNLIGHT 2: Part No. 003602010) to the contact point of the release lever and
operating cylinder.
Tightening torque:
T1: 18 Nm (1.8 kgf-cm, 13.0 ft. lbs.)
T2: 37 Nm (3.8 kgf-cm, 27.5 ft. lbs.)
2. After bleeding air from the operating cylinder, ensure that clutch operates properly.
INSPECTION
1. Check the operating cylinder for damage. If operating cylinder is damaged, replace it.