Legacy F4-2.5L DOHC Turbo (2005)
^
Apply grease (SUNLIGHT 2: Part No. 003602010) to the contact point of release lever and operating cylinder.
^
Observing from main case hole, check that the lever spring is installed securely.
2. Place the release bearing and fasten it with two clips.
3. Install the dust cover.
4. Check the bearing for smooth movement of with operating release lever.
5. Install the transmission assembly.
INSPECTION
RELEASE BEARING
NOTE: Since this bearing is grease-sealed and non-lubrication type, do not wash with gasoline or any solvent when servicing the clutch.
1. Check the bearing for smooth movement by applying force to the bearing in radial direction.
Radial direction stroke: 1.6 mm (0.063 inch)
2. Check the bearing for smooth rotation by applying force to the bearing in thrust direction.
3. Check wear and damage of bearing case surface contacting with lever.
RELEASE LEVER