Legacy F4-2.5L DOHC Turbo (2005)
1. Install the pitching stopper.
Tightening torque:
T1: 50 Nm (5.1 kgf-cm, 37 ft. lbs.)
T2: 58 Nm (5.9 kgf-cm, 43 ft. lbs.)
2. Install the air intake chamber and cleaner case. (Non-turbo model)
3. Install the intercooler. (Turbo model)
4. Connect the battery ground cable to battery.
CROSSMEMBER AND CUSHION RUBBER
1. Install the rear cushion rubber.
Tightening torque: 35 Nm (3.6 kgf-cm, 26 ft. lbs.)
2. Install the rear crossmember.
Tightening torque:
T1: 75 Nm (7.6 kgf-cm, 55 ft. lbs.)
T2: 140 Nm {14.3 kgf-cm. 103 ft. lbs.)
3. Remove the transmission jack.
4. Install the heat shield cover. (If equipped)
5. Install the front exhaust pipe. (Non-turbo model).
6. Install the center exhaust pipe. (Turbo model)
7. Install the rear exhaust pipe and muffler.
8. Lower the vehicle.
9. Connect the battery ground cable to battery.
INSPECTION
Perform the following inspection procedures and repair or replace defective parts.
PITCHING STOPPER
Check pitching stopper for bends or damage. Check that the rubber is not stiff, cracked, or otherwise damaged.
CROSSMEMBER AND CUSHION RUBBER
Check crossmember for bends or damage. Check that the cushion rubber is not stiff, cracked, or otherwise damaged.