Legacy F4-2.5L SOHC (2003)
Electronic Brake Control Module: Service and Repair
With ABS
ABS Control Module and Hydraulic Control Unit (ABSCM&H/U)
REMOVAL
1. Disconnect ground cable from battery
2. Remove air intake duct from engine compartment to facilitate removal of ABSCM&H/U.
3. Use an air gun to get rid of water around the ABSCM&H/U.
CAUTION: The contact will be insufficient if the terminal gets wet.
4. Pull off the lock of the ABSCM&H/U connector to remove it
5. Disconnect connector from ABSCM&H/U.
CAUTION: Be careful not to let water or other foreign matter contact the ABSCM&H/U terminal.
6. Unlock cable clip
7. Disconnect brake pipes from ABSCM&H/U.
CAUTION: Wrap brake pipes with vinyl bag to avoid spilling brake fluid on vehicle body.
8. Remove ABSCM&H/U ground terminal from bracket
9. Remove ABSCM&H/U from engine compartment
CAUTION:
^
ABSCM&H/U cannot be disassembled. Do not attempt to loosen bolts and nuts.
^
Do not drop or bump ABSCM&H/U.
^
Do not turn the ABSCM&H/U upside down or place it on its side.
^
Be careful to prevent foreign particles from getting into ABSCM&H/U.
^
Apply a coat of rust-preventive wax (Nippeco LT or GB) to bracket attaching bolt after tightening.
^
Do not pull harness when disconnecting connector.
INSTALLATION
1. Install ABSCM&H/U.
CAUTION: Confirm that the specifications of the ABSCM&H/U conforms to the vehicle specifications.
Tightening torque: 18 Nm (1.8 kgf-cm, 13.0 ft. lbs.)
