Legacy F4-2.5L SOHC (2003)
Impact Sensor: Service and Repair
Sensors
Side Airbag Sensor
REMOVAL
1. Turn ignition switch OFF.
2. Disconnect the ground cable from the battery, and wait for at least 20 seconds before starting work.
3. Remove center pillar lower trim.
4. Remove Outer Belt (FRONT).
5. Remove bracket (A), and then remove cap (B).
6. Remove two mounting nuts, and then detach side airbag sensor (A).
INSTALLATION
CAUTION: Use new mounting nuts during re-assembly. Install in the reverse order of removal.
Front Sub Sensor
REMOVAL
1. Turn ignition switch OFF.
2. Disconnect the ground cable from the battery, and wait for at least 20 seconds before starting work.
3. Remove front bumper.