Legacy F4-2.5L SOHC (2003)
Power Steering Pump: Service and Repair
Removal and Installation
Removal
REMOVAL
2.5 L MODEL
1. Remove ground cable from battery.
2. Remove pulley belt cover bracket.
3. Loosen lock bolt and slider bolt and remove power steering pump drive V-belt.
4. Disconnect connector from power steering pump switch.
5. Disconnect pipe C and suction hose from oil pump.
CAUTION:
^
Do not allow fluid from the hose end to come into contact with pulley belt.
^
To prevent foreign matter from entering the hose and pipe, cover the open ends of them with a clean cloth.
6. Remove bolts which install power steering pump bracket.
7. Place oil pump bracket in a vise, remove two bolts from the front side of oil pump.