Legacy F4-2.5L SOHC (2003)
CAUTION: When connecting, do not hit cap at the bottom of tie-rod end with hammer.
6. Install front stabilizer to vehicle.
7. Install front exhaust pipe assembly.
8. Install tires.
9. Tighten wheel nuts to the specified torque.
Tightening torque: 88 Nm (9.0 kgf-m, 65 ft. lbs.)
10. Connect battery ground cable.
11. Pour fluid into oil tank, and bleed air.
12. Check for fluid leaks.
13. Install jack-up plate.
WARNING: Be careful, exhaust manifold is hot.
14. Lower vehicle.
15. Check fluid level in oil tank.
16. After adjusting toe-in and steering angle, tighten lock nut on tie-rod end.
Tightening torque: 83 Nm (8.5 kgf-m, 61.5 ft. lbs.)
CAUTION: When adjusting toe-in, hold boot as shown to prevent it from being rotated or twisted. If twisted, straighten it.