Legacy F4-2.5L SOHC (2003)
2. Install ATF cooler pipe to frame.
3. Connect ATF cooler hose to pipe transmission side.
NOTE:
^
Install so that the hose is not folded over, excessively bent, or twisted.
^
Be careful to insert the hose to the specified position.
4. Connect ATF cooler hose to pipe of radiator side.
NOTE:
^
Install so that the hose is not folded over, excessively bent, or twisted.
^
Be careful to insert the hose to the specified position.
5. Install the under cover.
6. Install battery and washer tank.
7. Fill ATF.
NOTE: Make sure there are no ATF leaks in joints between the transmission, radiator, pipes, and hoses.
INSPECTION
Repair or replace any defective hoses, pipes, clamps, and washers found from the inspection below.
1. Check for ATF leaks in joints between the transmission, radiator, pipes, and hoses.
2. Check for deformed clamps.
3. Lightly bend the hose and check for cracks in the surface and other damage.
4. Pinch the hose with your fingers and check for poor elasticity. Also check for poor elasticity in the parts where the clamp was by pressing with
your fingernail.
5. Check for peeling, cracks, and deformation at the tip of the hose.