Legacy F4-2.5L SOHC (2003)
9. Install reduction driven gear.
10. Install the reduction drive gear. (MPT model)
11. Install the center differential carrier. (VTD model)
12. Combine the extension case with the transmission case, and install vehicle speed sensor 1 (rear).
13. Insert inhibitor switch and transmission connector into stay.
14. Install air breather hose.
15. Install the oil cooler pipe.
16. Install the oil charger pipe with O-ring.
17. Insert the input shaft while turning lightly by hand. At this time, not to damage the bushing.
Normal protrusion A: 50 - 55 mm (1.97 - 2.17 inch)
18. Install the torque converter clutch assembly.
19. Install the transmission assembly to the vehicle.
DISASSEMBLY
1. Remove four seal rings.