Legacy F4-2.5L SOHC (2003)
INSTALLATION
1. Install the select cable to base plate.
Tightening torque: 18 Nm (1.8 kgf-m, 13.0 ft. lbs.)
2. Install the select cable to range select lever.
3. Install the plate assembly to transmission.
Tightening torque: T: 24.5 Nm (2.5 kgf-cm. 18.1 ft. lbs.)
4. Install the washer and snap pin to range select lever.
5. Move the select lever to "N" position, then adjust the select cable position.
6. Install the heat shield cover. (If equipped)
7. Install the front and center exhaust pipe.