Legacy F4-2.5L SOHC (2003)
7. Remove free ring from trunnion.
CAUTION: Be careful with the free ring position.
8. Place alignment mark on trunnion and shaft.
9. Remove snap ring and trunnion.
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.
10. Remove SFJ boot.
11. Place drive shaft in a vise between wooden blocks.
CAUTION: Do not place drive shaft directly in the vise; use wooden block.
12. Raise boot band claws by means of screwdriver and hammer.
13. Cut and remove the boot.