Legacy F6-3.0L (2005)
10)
Re-route blue wiring harness under black wiring harness (and away from parking brake assembly and switch), then behind carpet starting at center
console location (see Figure 5) and exit through carpet opening at rear passenger heater vent (see Figure 6). Make sure to tuck wiring harness and
carpet under center console when finished.
Reassembly
1)
Re-connect sub-woofer wiring harness connector.
2)
Re-position seat and hand start bolts.
3)
Torque seat bolts to proper specification; 53 Nm (5.4 kgf-m, 39 ft-lb)
4)
Re-install drivers seat bolt covers at rear of slide rail.
5)
Re-install parking brake cover.
6)
Re-install ground cable to battery.
7)
Re-set radio stations.
8)
Re-set clock.
CLAIM REIMBURSEMENT/WARRANTY INFORMATION
Disclaimer
