Legacy F6-3.0L (2005)
7. Disconnect the harness connector (A), and then remove the motor assembly mounting bolts (B) and nuts (C).
INSTALLATION
CAUTION: When installing the motor assembly, be careful not to move the sunroof cable.
1. SEDAN MODEL
1. Align the coulisse assembly and link assembly in the same position.
2. Install the motor assembly.
3. Connect the harness connector of motor assembly, and then connect the battery ground cable to battery.
4. Perform the initialize operation of motor.
1. Tilt up the glass lid.
2. Release the switch once, and press the tilt up switch again for 15 seconds.
3. When the glass lid is raised a little and on tilt up position, release the switch for the moment.
4. Keep pressing the tilt up switch within 5 seconds from releasing the switch, glass lid tilts down -> slides open -> slides close operation
automatically, and then initialize operation is completed.
5. Check the operation of sunroof with table.
6. Install the trim in the reverse order of removal.
2. WAGON MODEL