Legacy F6-3.0L (2005)
Steering Angle Sensor: Service and Repair
REPLACEMENT
CAUTION:
^
Do not perform the removal except when the replacement.
^
When replacing more than three times, replace the combination switch as assembly to protect screw part.
1. Set the steering wheel in a wheel-forward position.
2. Disconnect the ground cable from battery.
3. Remove the airbag module.
WARNING: Always refer to "Airbag System" when performing the airbag module repair service.
4. Remove the steering wheel.
5. Remove the screws and detach the steering column lower cover.
6. Remove the two screws securing the steering column upper cover.
7. Unlock the harness band and disconnect the connector of steering angle sensor.
8. Remove the screws which secure the roll connector to steering column.
9. Remove the steering angle sensor from roll connector.