Legacy F6-3.0L (2005)
NOTE: Setting is different depending on grade of vehicle.
CAUTION:
-
It is possible to control the original functions of vehicle when registrations of body integrated unit and function setting are corresponded to
vehicle equipment.
-
When body integrated unit is new one or "Factory" mode, key illumination blinks to show equipment settings does not completed.
-
Be sure not to change Factory initial setting except installation of new body integrated unit.
NOTE:
"Factory" mode:
-
Body integrated unit has not been set yet. It can be recognized by key illumination blinking with ignition switch turned to ON.
-
All body integrated units for repair parts are set to "Factory" mode. When replacing a body integrated unit, be sure to perform the
registration operation.
"Market" mode:
Each settings have been set. It can be recognized by key illumination coming on in concocting with room light and going off with ignition
switch turned to ON.
7. Perform the Factory setting. On the "ECM customizing" display screen of Subaru Select Monitor, select the {Factory initial setting} and press
the [YES] key.
8. Change the mode from Factory into Market.
9. Replace the immobilizer cartridge, and register the immobilizer key. (Model with immobilizer)
10. Perform the registration according to the procedures of "IMMOBILIZER REGISTRATION MANUAL".
11. When key registration is completed, "Do you want to register remote engine start?" is displayed.
Perform the registration only if equipped.
12. Perform the function setting (ECM customizing).
NOTE: For details concerning operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
7. CLEAR MEMORY MODE
1. On the "Main Menu" display screen, select the {2. Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select the {Integ. Unit mode} and press the [YES] key.
3. Press [YES] key after displayed the information of body integrated unit type.
4. On the "Integ. Unit mode failure diag" display screen, select the {Clear Memory} and press the [YES] key.
5. When the "Done" are shown on the display screen, turn the ignition switch to OFF.
NOTE: For detailed operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
8. FREEZE FRAME DATA
NOTE:
-
Data stored at the time of trouble occurrence is shown on display.
-
Freeze frame data will be memorized maximum to 20.
-
If freeze frame data is not stored in memory correctly (caused by low power supply of body integrated unit), DTC will be displayed with "?"
on the head of it in the Subaru Select Monitor display. This shows it may be an unreliable reading.
9. FUNCTION SETTING (ECM CUSTOMIZING)
1. On the "Main Menu" display screen, select the {Each System Check} and press the [YES] key.
2. On the "System Selection Menu" display screen, select the {Integ. Unit mode} and press the [YES] key.
3. On the "Integ. Unit mode failure diag" display screen, select the {ECM customizing} and press the [YES] key.
