Legacy F6-3.0L (2005)
9.
Remove B-Pillar lower trim covers (it will stay attached to the Seat Belt) and position it safely out of the way to avoid damaging it or other interior
parts.
10.
Remove B-Pillar upper trim by carefully removing the cap on the upper portion of the pillar trim. Remove the bolt.
11.
Remove center interior Room Light Lens, Room Light, and disconnect wiring connector.
12.
Remove C-Pillar upper trim and trim cover.
(1)
Carefully pull on trim cover to gain access to the metal clip. Slide a mini screwdriver under metal tab and push upward to disengaged clip.
Carefully remove trim cover.
^
Removal of this trim can be accomplished without removal of the rear seat, however removal is easier with the rear seat removed.
^
If you leave the rear seat installed, to ease removal of upper C-Pillar trim bolts, remove rear seatback Headrests LH/RH and lay aside.
(2)
Carefully remove the cap on the upper portion of the C-Pillar trim. Remove the 4 Bolts to remove the trim.
13.
Disconnect the antenna lead at the connector located by the driver's side C-Pillar.
