Legacy F6-3.0L (2005)
2. Connect the pipe C and D to gearbox. Tightening torque:
Pipe C: 37 Nm (3.8 kgf-cm, 27.3 ft. lbs.)
Pipe D: 29 Nm (3.0 kgf-cm, 21.4 ft. lbs.)
Installation
The content of this article/image reflects the changes Identified in
TSB # 18-97-06
as of 01/04/06
and applies to 2005 Legacy and Baja models
Steering Gearbox
INSTALLATION
1. Insert the gearbox into crossmember, being careful not to damage gearbox boot.
2. Install the gearbox and bracket. Tighten the bolt temporarily.
3. Tighten the gearbox to the crossmember bracket via clamp with bolt temporarily.
4. Tighten the bolts which temporary tightening the clamp and bracket of gearbox to specified torque.
Tightening torque: 60 Nm (6.1 kgf-cm, 44.1 ft. lbs.)