subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Steering Gear|Removal|Page 4001 > < Steering Gear|Removal|Page 3999
Page 28
background image

17. Align the center of roll connector.
18. Install the steering wheel.
19. Connect the battery ground cable to battery.
20. Pour fluid into the oil tank, and bleed air.
21. Check for fluid leaks.
22. Check the fluid level in oil tank.

23. After adjusting toe-in and steering angle, tighten the lock nut on tie-rod end.

Tightening torque: 85 Nm (8. 7 kgf-cm, 62.7 ft. lbs.)

NOTE:  When adjusting toe-in, hold the boot as shown to prevent it from being rotated or twisted. If twisted, straighten it.

Adjustment

Steering Gearbox 

ADJUSTMENT

1. Adjust the front toe.

Standard of front toe: IN 3-OUT 3 mm (IN 0.12-OUT 0.12 inch)

2. Adjust the steering angle of wheels.

Standard of steering angle:

Steering Gear|Removal|Page 4001 > < Steering Gear|Removal|Page 3999