Legacy F6-3.0L (2005)
7. After tightening the axle nut, lock it securely.
8. Install the wheel and tighten the wheel nuts to specified torque.
Tightening torque: 110 Nm (11.2 kgf-cm, 81.1 ft. lbs.)
DISASSEMBLY
Using the ST and a hydraulic press, drive hub bolts out.
ST 28399AG000 HUB STAND
CAUTION:
^
Be careful not to hammer the hub bolts. This may deform the hub.
^
Do not reuse the hub bolt.
NOTE: Since the hub unit bearing can not be disassembled, only hub bolts can be removed.
ASSEMBLY
1. Attach the hub to ST securely.
ST 927080000 HUB II STAND
2. Using a press, press new hub bolts until their seating surfaces contact the hub.
NOTE: Use 12 mm (0.47 inch)dia. holes in HUB STAND to prevent bolts from tilting.
INSPECTION
Refer to FRONT AXLE for inspection procedures.
CAUTION: If there is any fault in the bearing, replace hub unit bearing.
