Legacy F6-3.0L (2005)
5. Install the radiator under cover.
Tightening torque: 4.9 Nm (0.5 kgf-cm, 3.6 ft. lbs.)
6. Install the under cover.
7. Install the battery.
8. Fill ATF.
NOTE: Make sure there are no ATF leaks in joints between the transmission, radiator, pipes, and hoses.
INSPECTION
Repair or replace any defective hoses, pipes, clamps, and washers found from the inspection below.
1. Check for ATF leaks in joints between the transmission, radiator, pipes, and hoses.
2. Check for deformed clamps.
3. Lightly bend the hose and check for cracks in the surface and other damages.
4. Pinch the hose with your fingers and check for poor elasticity. Also check for poor elasticity in the parts where the clamp was installed by pressing
with your fingernail.
5. Check for peeling, cracks, and deformation at the tip of the hose.
