Legacy Brighton Wagon AWD F4-2.2L SOHC (1997)
(3) Pry oil seal off using a screwdriver.
CAUTION: Be careful not to scratch inner surface of casing.
4) Remove pressure switch.
Inspection
INSPECTION
Perform the following inspection procedures and repair or replace defective parts.
Assembly
ASSEMBLY
1) Reassembly precautions
(1) Whenever 0-rings, oil seals, and snap rings are removed, they must be replaced with new ones.
(2) Thoroughly wash parts and allow to dry. They must be kept free from cleaning oil and dust.
(3) Reassembly procedure must be performed in clean place. Ensure that parts are kept away from waste threads or other dust particles.
(4) Cleaning oil lends to stay inside the front casing. Remove it completely by blowing compressed air.
(5) Ensure that parts are tree from rust. (Use specified hydraulic oil for rust prevention after cleaning and drying.)
(6) Reverse the sequence of disassembly procedures.