Legacy Brighton Wagon AWD F4-2.2L SOHC (1997)
7. Install the following parts to the rear section of transmission main shaft.
-
Needle bearing (32 x 36 x 25.7)
-
5th drive gear
-
Baulk ring
-
Sleeve (A) and hub assembly
-
Insert stopper plate (B)
-
Lock washer (C) (22 x 38 x 2)
-
Tighten lock nuts (D) (22 x 13) to the specified torque using ST1 and ST2.
ST1 499987003 SOCKET WRENCH (35)
ST2 498937000 TRANSMISSION HOLDER
NOTE:
-
Align groove (E) in baulk ring with shifting insert.
-
Be sure to fit pawl (F) of insert stopper plate into 4 mm (0.16 inch) diameter hole in the boss section of synchronizer hub.
-
Secure lock nuts in two places after tightening.