Interior Floor Mat Replacement for Legacy Brighton Wagon (2000) - Service
Floor Mat: Service and Repair
REMOVAL AND INSTALLATION
Removal order of floor mat is as follows:
1. Remove front seats.
2. Remove rear seat cushion.
3. Remove console box, depending on the specifications.
4. Remove front pillar lower trim panel.
5. Remove center pillar lower trim panel.
6. Remove side sill rear upper cover.
7. Remove clips from floor mat.
NOTE: When pulling out edge, do not pull mat alone; pull mat together with edge. Pry off two steel clips on side sill front cover and one on side
sill rear cover using screwdriver.
8. Remove mat hook.
9. Remove mat from toe board area.
10. Remove mat from rear heater duct.
11. Roll mat, then take it out of opened rear door.
12. Installation is in the reverse order of removal.
NOTE:
-
Secure mat firmly with hook and velcro tape.
-
Insert mat edge firmly into the groove of side sill cover.
Removal order of rear floor box is as follows:
1. Remove clips, then detach rear floor boxes.
2. Installation is in the reverse order of removal.
