Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
2. Loosen throttle position sensor holding screws.
3. When using voltage meter;
1. Take out ECM.
2. Turn ignition switch to ON.
3. Adjust throttle position sensor to the proper position to allow the voltage signal to ECM to be in specification.
Connector & terminal / Specified voltage
(B136.No.15-(B136.No.17/0.45 - 0.55 V [Fully closed.]
4. Tighten throttle position sensor holding screws.
Tightening torque:
2.2 ± 0.2 N.m (0.2 ± 0.02 kg.m 16 ± 0.1 ft.lb)
4. When using Subaru Select Monitor;
1. Turn ignition switch to OFF.