subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Seat Belt Pretensioner <--> [Seat Belt Tensioner]|Removal and Installation|Page 5047 > < Seat Belt Pretensioner <--> [Seat Belt Tensioner]|Removal and Installation|Page 5045
Page 3
background image

5. Short deployment tool alligator clip to terminal.

Deployment tool: (PN. 98299PA030)

CAUTION:  Deployment tool should be kept shorted until just before deployment of ELR with pretensioner.

6. Connect deployment tool connector (1D) and ELR with pretensioner "YELLOW" connector.
7. Bundle three wire automotive harnesses [each with a sectional area of 1.25 sq. mm (0.00194 sq. in) or more] and bind them two folds around ELR

with pretensioner bracket.

8. Install ELR with pretensioner on disk wheel with tire attached.

9. Pile three tires without disk wheel upon the tire installed with ELR with pretensioner. Pile upon this an additional tire with disk wheel. Fasten this

pile tight with rope.

10. Extend deployment tool to the limit. Secure area. Then connect deployment tool alligator clip to battery minus terminal and the other terminal to

battery plus terminal.

Seat Belt Pretensioner <--> [Seat Belt Tensioner]|Removal and Installation|Page 5047 > < Seat Belt Pretensioner <--> [Seat Belt Tensioner]|Removal and Installation|Page 5045