Legacy Brighton Wagon AWD F4-2.5L SOHC (2000)
Using ST-A, B. press bushing out of place.
ST-A, B 20099AE000 INSTALLER & REMOVER
C: INSPECTION
Visually check link rear for damage or bends.
D: ASSEMBLY
Using ST, press bushing into place.
ST-A, B 20099AE000 INSTALLER & REMOVER
E: INSTALLATION
To install, reverse removal procedures, observing the following instructions.
CAUTION:
-
Using transmission jack, support rear arm horizontally, install link rear and tighten nuts to specified torque
-
Tighten nut when installing adjusting bolt.
-
Replace self-locking nut.
NOTE: Check wheel alignment and adjust if necessary
10. Link Upper
A: REMOVAL