Legacy GT Wagon AWD F4-2.5L DOHC (1997)
3. Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4. Insert piston into cylinder.
CAUTION: Do not force piston into cylinder.
5. Apply a coat of specified grease to boot and fit in groove on ends of cylinder and install piston boot onto cylinder.
Grease: NIGLUBE RX-2 (Part No. 003606000) or equivalent.
6. Install the piston boot to the caliper body, and attach boot ring.
7. Apply a coat of specified grease to guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.
Grease: NIGLUBE RX-2 (Part No. 003606000) or equivalent.
8. Install guide pin boot on caliper body.
9. Install lock pin boot on caliper body and insert lock pin sleeve into place.
INSTALLATION
1. Install disc rotor on hub.
2. Install support on housing.
Tightening torque: 52 ± 6 Nm (5.3 ± 0.6 kg-m, 38.3 ± 4.3 ft. lbs.)
CAUTION:
^
Always replace the pads for both the left and right wheels at the same time. Also replace pad clips if they are twisted or worn.
^
A wear indicator is provided on the inner disc brake pad. If the pad wears down to such an extent that the end of the wear indicator contacts the
disc rotor, a squeaking sound is produced as the wheel rotates. If this sound is heard, replace the pad.
^
Replace pads if there is oil or grease on them.
3. Apply thin coat of PBC GREASE (Part No. 003607000) or equivalent to the frictional portion between pad and pad clip.