Legacy GT Wagon AWD F4-2.5L DOHC (1997)
1. Connect diagnosis terminals to terminals No. 3 and No. 6 of the diagnosis connector beside driver's seat heater unit.
2. Set the speed of all wheels at 4 km/h (2 MPH) or less.
3. Turn ignition switch OFF.
4. Within 0.5 seconds after the ABS warning light goes out, depress the brake pedal and hold it immediately after ignition switch is turned to ON.
CAUTION: Do not depress the clutch pedal.
NOTE:
^
When the ignition switch is set to on, the brake pedal must not be depressed.
^
Engine must not operate.
5. After completion of ABS sequence control, turn ignition switch OFF.
OPERATIONAL GUIDELINES OF THE ABS SEQUENCE CONTROL WITH SELECT MONITOR
NOTE: In the event of any trouble, the sequence control may not be operative. In such a case, activate the sequence control, referring to
"OPERATIONAL GUIDELINES OF THE ABS SEQUENCE CONTROL WITH DIAGNOSIS CONNECTOR".
1. Connect select monitor to data link connector beside driver's seat heater unit.
2. Turn ignition switch ON.
3. Put select monitor to ABS mode.
4. Press F D 1 ENT key.
5. The message shown in the figure is displayed.
6. The message shown in the figure is displayed as follows:
(1) When using the brake tester, depress brake pedal with braking force of 981 N (100 kg, 221 lbs.).
(2) When using the pressure gauge, depress brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm sq., 498 psi).
CAUTION: Do not depress the clutch pedal.