Legacy GT Wagon AWD F4-2.5L DOHC (1997)
3. Install drive pinion collar (5), needle bearing (6) (25 x 30 x 20), adjusting washer No. 2 (7) (25 x 36 x 4), thrust bearing (8) (25 x 37.5 x 3),
adjusting washer No. 1 (9) (25 x 36 x t) and differential bevel gear sleeve (10) in that order.
NOTE: Be careful because spacer must be installed in proper direction. (A): Driven Shaft or (B): Driven Pinion Shaft.
ADJUSTMENT OF THRUST BEARING PRELOAD
1. After completing the preceding steps 1 through 3, select adjusting washer No. 2 so that dimension (H) is zero through visual check. Position
washer (18.3 x 30 x 4) and lock washer (18 x 30 x 2) and install lock nut (18 x 13.5).
2. Using ST1, ST2 and ST3, tighten lock nut to 118 +/-8 Nm (86.8 +/-5.8 ft. lbs.). ST1 899884100 Holder, ST2 498427100 Stopper or ST3
899988608 Socket Wrench (27), or equivalent.
3. After removing ST2, measure starting torque using torque driver. ST1 899884100 Holder or ST3 899988608 Socket Wrench (27), or equivalent.