Legacy GT Wagon AWD F4-2.5L DOHC (1997)
3. Mount the following parts on the gearshift lever.
CAUTION:
-
Always use new O-rings.
-
Apply grease [NIGLUBE-R or equivalent] to the inner surface of the bush.
4. Mount gearshift lever on the stay.
5. Install snap ring to the case of the stay.
6. Tighten with locking wire to the extent that the boot will not come off.
CAUTION: Always use new locking wire.
7. Insert the rod into the boot hole.
8. Connect rod to gearshift lever.