Legacy L Wagon AWD F4-2.5L SOHC (2001)
15. Align alignment marks on shaft and outer race, and install outer race.
16. Install circlip in the groove on SFJ outer race.
CAUTION: Pull the shaft lightly and assure that the circlip is completely fitted in the groove.
17. Apply an even coat of the specified grease 30 to 40 g (1.06 to 1.41 oz.) to the entire inner surface of boot.
18. Install SFJ boot taking care not to twist it.
CAUTION:
^
The inside of the larger end of SFJ boot and the boot groove shall be cleaned so as to be free from grease and other substances.
^
When installing SFJ boot, position outer race of SFJ at center of its travel.
19. Put a band through the clip and wind twice in alignment with band groove of boot.
CAUTION: Use a new band.
20. Pinch the end of band with pliers. Hold the clip and tighten securely.
NOTE: When tightening boot, exercise care so that the air within the boot is appropriate.
21. Tighten band by using ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE: Tighten band until it cannot be moved by hand.
22. Tap on the clip with the punch provided at the end of ST.
ST 925091000 BAND TIGHTENING TOOL
CAUTION: Tap to an extent that the boot underneath is not damaged.
23. Cut off band with an allowance of about 10 mm (0.39 in) left from the clip and bend this allowance over the clip.
CAUTION: Be careful so that the end of the band is in close contact with clip.