Legacy Outback Limited AWD F4-2.5L DOHC (1998)
1) Adjust tire pressure to specification.
2) Set vehicle under "curb weight" conditions. (Empty luggage compartment, install spare tire, jack, service tools, and top up fuel tank.)
3) Set steering wheel in a wheel-forward position.
4) Suspend thread from wheel arch (point "A" in figure below) to determine a point directly above center of spindle.
5) Measure distance between measuring point and center of spindle.
Camber and Caster Inspection
1. Place front wheel on turning radius gauge. Make sure ground contacting surfaces of front and rear wheels are set at the same height.
2. Set ST into the center of the wheel, and then install the wheel alignment gauge.
ST 927380000 Adapter
Front Camber Adjustment
