Legacy Outback Ltd Sedan F4-2.5L SOHC (2000)
Airbag Control Module: Service and Repair
REMOVAL AND INSTALLATION
CAUTION:
Do not disassemble the airbag control module.
If the airbag control module is deformed, or if water damage is suspected, replace the air-bag control module with a new genuine part.
After removal, keep the airbag control module on a dry, clean surface away from heat and light sources, and moisture and dust.
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover.
4. Remove console box.
5. Disconnect connector from airbag control module.
6. Using T40 TORX(R) bit (Tamper resistant type), remove four TORX(R) bolts in numerical sequence shown in figure. Discard the old TORX(R)